Quick Answer
To properly adjust your scope for 6x47 Lapua, start by dialing in the bullet drop at 100 yards and then fine-tune at longer ranges. Use the MOA markings or mil-dot reticle to make adjustments and verify the impact. Make sure to account for scope elevation and wind deflection.
Setting the Bullet’s Point of Impact
When adjusting your scope for a 6x47 Lapua, it’s essential to start at 100 yards. This is because most shooting ranges and benchrest setups are calibrated for this distance. Begin by dialing in the bullet drop using the scope’s MOA or mil-dot reticle. The typical bullet drop for a 6x47 Lapua at 100 yards is around 3-4 MOA. To achieve this, turn the elevation dial clockwise for a high-powered rifle like the 6x47 Lapua.
Fine-Tuning at Longer Ranges
Once you’ve dialed in the bullet drop at 100 yards, it’s time to fine-tune at longer ranges. For longer shots, make adjustments in 1/4 MOA increments, as this will be more precise than the 1 MOA increments typically used at closer ranges. When making adjustments, use the wind deflection charts and scope elevation markings to ensure accurate bullet placement. The 6x47 Lapua’s high ballistic coefficient allows for longer effective ranges, but it still requires precise adjustments to achieve optimal results.
Maintaining Scope Calibration
To maintain scope calibration, regularly check your rifle’s point of impact at the same distance and conditions. This is crucial for varmint hunting, where long shots are common. Additionally, always double-check your scope’s zero after any modifications, such as changing the barrel or optic. By following these steps, you’ll be able to accurately dial in your scope for a 6x47 Lapua and achieve impressive results on varmint hunts.
Find more answers
Browse the full Q&A library by topic, or jump back to the topic this question belongs to.